1996 Pontiac Grand Am Repair Question
Topics covered: Abs, Brakes, Abs module.
Mileage: No information provided.
Mileage: No information provided.
Asked on April 24, 2009
1996 Pontiac Grand Am malfunctioning abs module?
Brakes problem
1996 Pontiac Grand Am 6 cyl Front Wheel Drive Automatic 110k miles
my car's front passenger side brakes keep sticking (they don't release after engages) at times and many mechanic's told me that it was the caliper. I replaced the caliper with a brand new one, but the problem persists. The brakes get so hot to the point of burning (not to mention they wear extremely fast). This only happens with the front passenger side (its the only wheel that gets hot) After I turn off the car, I can hear the car's brakes groaning as if trying to release. Two different mechanics so far have told me it might be the ABS module that is malfunctioning and not releasing the hydraulic pressure. If that is the case, is it something I can fix myself (I even ordered a replacement) or do I have to get it professionally installed? If so how much would that cost me as I cannot keep changing both the brake discs and the actual brakes.
1996 Pontiac Grand Am 6 cyl Front Wheel Drive Automatic 110k miles
my car's front passenger side brakes keep sticking (they don't release after engages) at times and many mechanic's told me that it was the caliper. I replaced the caliper with a brand new one, but the problem persists. The brakes get so hot to the point of burning (not to mention they wear extremely fast). This only happens with the front passenger side (its the only wheel that gets hot) After I turn off the car, I can hear the car's brakes groaning as if trying to release. Two different mechanics so far have told me it might be the ABS module that is malfunctioning and not releasing the hydraulic pressure. If that is the case, is it something I can fix myself (I even ordered a replacement) or do I have to get it professionally installed? If so how much would that cost me as I cannot keep changing both the brake discs and the actual brakes.
Asked by xfoxx9Answer
Replied on April 25, 2009
Before replacing ABS module, I would have ABS scanned with ABS scanner, look for any codes.
Many GM cars are VIN specific with regard to PCM's and ABS modules, they would have to be flashed by dealer with specific VIN of vehicle.
So I would do a little more diagnosis before replacing module.
Replied on November 24, 2011
I personally would go the easy and cheapest route and replace the collapsed rubber line that goes to the caliper.