1996 Honda Accord CV axles

Tiny
ZEMORZEMOR
  • MEMBER
  • 1996 HONDA ACCORD
  • 232,000 MILES
Hi Sir
When I push up and pull down on the inner part of the Cv axle it moves and hear clicks. But the cv joint they do not make clicking when I turn right or left. Is it a bad cv axles.

can you tell me how to check CV axles and wheel bearing. I have floor jack and jack stands and handy tools

Thank you
Do you
have the same problem?
Yes
No
Wednesday, July 31st, 2013 AT 8:43 AM

3 Replies

Tiny
KHLOW2008
  • MECHANIC
  • 41,815 POSTS
Minimal free in the inner CV joints are normal and if boots are not torn with no signs of cv gtrease spilled all over, joint should be good.

Bad wheel bearings would produce groaning noises while driving at higher speeds.
You can jack up and check wheel bearings for axial play.
Was this
answer
helpful?
Yes
No
Thursday, August 1st, 2013 AT 8:52 AM
Tiny
ZEMORZEMOR
  • MEMBER
  • 486 POSTS
I hear noise when I drive the car in high speed like 40 mph but its not groaning noise. I think its tire noise how can I make sure its the tire that make noise or brake pads making contacts with rotors.

Thank you
Was this
answer
helpful?
Yes
No
+1
Thursday, August 1st, 2013 AT 9:01 AM
Tiny
KHLOW2008
  • MECHANIC
  • 41,815 POSTS
Jack up wheel and turn them to see if there are any abnormal noises.
Was this
answer
helpful?
Yes
No
Thursday, August 1st, 2013 AT 9:03 AM

Please login or register to post a reply.

Sponsored links