CRANK SHAFT SENSOR STOP FUEL ?
1996 GMC Jimmy • 250,000 miles
Gmc 4.3l how does the crank shaft sensor stop fuel flow to the injectors when all injectors are stopping correctly? Needing to know how the sensor affects the fuel flow and how can it stop fuel flow completely
The CPS has nothing to do with stopping fuel from entering the engine, check to see if you have a shorted injector causing the problem, go here for more info.
Ok well I have good power and all injectors are strobing their are two that have contant power with ignition in on setting then they stobe fine when cranked over but I'm not getting fuel out of injectors
Ok, well I have good power and all injectors are pulsing, but I'm not getting fuel out of one injector.
Hi hope you can help, this is a general question. 2 wire sensors, crank and cam are referred to as inductive, magnetic, whilst 3 wire sensors are Hall effect. Can a inductive, magnetic ...
3 answers • 2010 All Other Makes All Other Models
2007 toyota camry 140k. Check engine light code Knock sensor. Reset and came back on right away. What could cause this other than the obviouse bad sensor or wire?
9 answers • 2007 Toyota Camry • 140 miles
I had a rough starting when cold issue. Checked the codes and discovered two codes for a lean condition in both banks. After not finding a vac leak, I replaced the MAF with a ...
2 answers • 2002 Chevrolet Silverado • 170,779 miles
Describe the type sensor of the Knock sensor is on this vehicle and how it should be tested.?
1 answer • 2002 Chrysler 300 • 100 miles