96 ford ranger slave cylider issues

1996 FORD RANGER
Avatar
RUBEN541
  • MEMBER
  • 33 POSTS
i recently replaced the slave cylinder but its not going into gear. i bled the slave cylinder several times and the clutch pedal goes down to the floor i also replaced the clutch line and master cylinder and im still having the same issue
Sep 16, 2012 at 8:47 PM
Advertisement
Avatar
ASEMASTER6371
  • CAR REPAIR CONTRIBUTOR
  • 52,796 POSTS
you still have air trapped in the line. bleed it with the top off the master.

Roy
Sep 16, 2012 at 8:49 PM
Avatar
RUBEN541
  • MEMBER
  • 33 POSTS
i tried that already and im still having the same issue
Sep 16, 2012 at 9:32 PM
Avatar
ASEMASTER6371
  • CAR REPAIR CONTRIBUTOR
  • 52,796 POSTS
be patient and keep bleeding it.

Roy
Sep 16, 2012 at 10:05 PM
Avatar
RUBEN541
  • MEMBER
  • 33 POSTS
i been bleeding it for 2 days
Sep 16, 2012 at 10:06 PM
Avatar
ASEMASTER6371
  • CAR REPAIR CONTRIBUTOR
  • 52,796 POSTS
did you use a new master with the line??

Roy
Sep 16, 2012 at 10:18 PM
Avatar
RUBEN541
  • MEMBER
  • 33 POSTS
yes i did i replaced the master cylinder slave cylinder and the new line
Sep 16, 2012 at 10:24 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.