1996 Fiat Cinquecento • 67,000 miles
I have a 1996 fiat cinquecento 900cc sx which came with just a speedo and a fuel gague as standard and nothing else I have fitted a set of sporting clocks and wired the rev counter in and everything else works execpt the temp gague I have been trying for some time to figure out how to wire the three contacts in to get a correct reading but have not had much luck and on occasion it has caused the warning light for the injector to come on when contact was made with the coolant temp sensor on the thermostat housing for some reason not sure why. Can anyone help with a wiring diagram or simple way to wire it up ???? I dont want to fit an aftermarket one which would mean drilling into the head or thermostat for the new sensor peg !!!!!!!
June 7, 2012.
June 7, 2012.
Hi hope you can help, this is a general question. 2 wire sensors, crank and cam are referred to as inductive, magnetic, whilst 3 wire sensors are Hall effect. Can a inductive, magnetic ...
3 answers • 2010 All Other Makes All Other Models
I have a 2000 bonneville ssei. It has 2 02 sensors. I get the code that says cat. sys. efficency level low bank 1. Is that the upstream 02 or the downstream 02
1 answer • 2000 Pontiac Bonneville • 150,000 miles
The service manual for my 1996 GMC Sierra tells me that my truck has four oxygen sensors. They are designated: Bank 1 Sensor 1, Bank 1 Sensor 2, Bank 1 Sensor 3, and, Bank 2 Sensor 1. ...
1 answer • 1996 GMC Sierra • 125,000 miles
I had a rough starting when cold issue. Checked the codes and discovered two codes for a lean condition in both banks. After not finding a vac leak, I replaced the MAF with a ...
2 answers • 2002 Chevrolet Silverado • 170,779 miles