1996 Fiat Cinquecento • 67,000 miles
I have a 1996 fiat cinquecento 900cc sx which came with just a speedo and a fuel gague as standard and nothing else I have fitted a set of sporting clocks and wired the rev counter in and everything else works execpt the temp gague I have been trying for some time to figure out how to wire the three contacts in to get a correct reading but have not had much luck and on occasion it has caused the warning light for the injector to come on when contact was made with the coolant temp sensor on the thermostat housing for some reason not sure why. Can anyone help with a wiring diagram or simple way to wire it up ???? I dont want to fit an aftermarket one which would mean drilling into the head or thermostat for the new sensor peg !!!!!!!
June 7, 2012.
June 7, 2012.
Just wondering what sensors i need to replace.codes as follows.p0135,p0155,p0133.two of the codes say bank 1 sensor 1 the other says bank2 sensor 1.I think bank means driver or ...
2 answers • 2002 Dodge Intrepid • 100,500 miles
Hi hope you can help, this is a general question. 2 wire sensors, crank and cam are referred to as inductive, magnetic, whilst 3 wire sensors are Hall effect. Can a inductive, magnetic ...
3 answers • 2010 All Other Makes All Other Models
I had a rough starting when cold issue. Checked the codes and discovered two codes for a lean condition in both banks. After not finding a vac leak, I replaced the MAF with a ...
2 answers • 2002 Chevrolet Silverado • 170,779 miles
Describe the type sensor of the Knock sensor is on this vehicle and how it should be tested.?
1 answer • 2002 Chrysler 300 • 100 miles