1996 Acura TL Repair Question
96 Acura 2.5TL. My car doesn't support much weight in the rear anymore. Do i need to replace the Struts/Suspension coils?
correction* Car has over 214 thousand miles..not 214.
8 questions asked
yes it's probably an accurate description. i'd advise replacing springs as well. you will need a compressor to put the spring on but alot of auto parts stores will doit for a minimal charge. so you just need to replace the strut assy.
WARNING: Strut contains pressurized nitrogen gas. To dispose of properly, drill a 5/64" (2.0 mm) hole at base of strut. Always wear eye protection when drilling.
1. Lift and support vehicle. Remove wheel assembly. Remove rear seat. Remove strut mounting base nuts. See Fig. 2 .
2. Place floor jack under lower control arm. Compress strut slightly. Remove strut lower mounting nut. Lower rear suspension. Remove strut assembly.
Fig. 2: Exploded View Of Strut Assembly
Courtesy of AMERICAN HONDA MOTOR CO., INC.
1. Compress strut spring with spring compressor. DO NOT compress spring more than necessary to remove 10 mm self locking nut. Remove 10 mm self locking nut from strut assembly.
2. Remove spring compressor. Note component locations, and complete disassembly by removing components.
Check for smooth operation in both compression and extension strokes. Check for oil leaks, abnormal noises, or binding. Replace strut as necessary.
Reassembly & Installation
To reassemble, reverse disassembly procedure. To install, reverse removal procedure.
17,813 answers provided