SPONSORED LINKS

No start and no communication with snap on modis scanner

Tiny
LOUIELEWIS
  • MEMBER
  • 1995 MITSUBISHI EXPO
  • 198,000 MILES
I have a no start on my 1995 mitsubishi expo 2.4l.I have fuel and spark.I have an ignition switch that I have to turn on and off a few times before it works but it still turns over.I also have a snap on scanner ( Modis ) with the correct mitsu-1 adapter and the key7 attatchment but I get a no communication everytime I hook it up. It says obd1 under the hood on the emmisions tag but it has an obd II connector under the dash so I am not sure how to check for codes.I am lost. Please help
SPONSORED LINKS
Wednesday, December 28th, 2011 AT 8:24 PM

8 Replies

Tiny
RIVERMIKERAT
  • MECHANIC
  • 6,110 POSTS
It sounds as though you have an issue with the ignition switch that needs to be addressed first.
Was this
answer
helpful?
Yes
No
Wednesday, December 28th, 2011 AT 8:31 PM
Tiny
RASMATAZ
  • MECHANIC
  • 75,992 POSTS
Check and test the ignition switch, fuel pressure if its within specs and verify the valve and ignition timing-
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
Wednesday, December 28th, 2011 AT 8:31 PM
Tiny
LOUIELEWIS
  • MEMBER
  • 4 POSTS
Would the ignition switch being semi faulty cause the no communication with the scanner? And also a no start? I mean when it turns over it turns over good
Was this
answer
helpful?
Yes
No
Wednesday, December 28th, 2011 AT 8:48 PM
Tiny
RIVERMIKERAT
  • MECHANIC
  • 6,110 POSTS
Yes, it could cause the no start condition. The switch may not be sending the signal to power up the ignition primary circuit.

The no communication issue is probably a loose connector pin or broken wire.
Was this
answer
helpful?
Yes
No
Wednesday, December 28th, 2011 AT 9:02 PM
Tiny
LOUIELEWIS
  • MEMBER
  • 4 POSTS
Even if when the ignition switch is rolling over and over it is getting park at the plugs
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
Wednesday, December 28th, 2011 AT 11:09 PM
Tiny
RIVERMIKERAT
  • MECHANIC
  • 6,110 POSTS
You have engine turning over and spark, but it's not starting?
Check all fuses and relays.
Was this
answer
helpful?
Yes
No
Wednesday, December 28th, 2011 AT 11:49 PM
Tiny
LOUIELEWIS
  • MEMBER
  • 4 POSTS
I checked all fuses and relays
Was this
answer
helpful?
Yes
No
Thursday, December 29th, 2011 AT 9:32 PM
Tiny
RIVERMIKERAT
  • MECHANIC
  • 6,110 POSTS
See images. Test continuity on the lines to and from the data connector.
Images (Click to make bigger)
Thumb
Thumb
Was this
answer
helpful?
Yes
No
+1
Thursday, December 29th, 2011 AT 10:12 PM

Please login or register to post a reply.

Related Engine Not Running Content

How to fix an engine that wont start
VIDEO
How to fix an engine that wont start
Instructional repair video
Engine Not Starting - Top 3 Easy Steps
GUIDE
Engine Not Starting - Top 3 Easy Steps
Over the past 20 years on 2CarPros we have identified the top three problems that are easily fixed. This can save you a trip to the repair garage or calling a tow truck and...

Sponsored links