95 honda accord cv issue?

1995 HONDA ACCORD
134 MILES • 4 CYL • FWD • MANUAL
Avatar
MIKE3691
  • MEMBER
  • 1 POST
I have a 95 honda accord and my passenger side rattles and clanks when i turn and when i get to about 50 mph it does the same and my steering wheel shakes. i think its a cv joint. what might be your diagnosis?
Dec 18, 2010 at 3:17 AM
Advertisement
Avatar
HONDAMIKE
  • CAR REPAIR CONTRIBUTOR
  • 71 POSTS
On a slow turn (like a U-turn) is when you will here the CV joint make the most noise (usually from a stop). If you hear noise and the steering wheel shakes at 50mph, there could be something else wrong. Possibly loose lugnuts, bearing, brakes, tire, and/or wheel problems. I would have it looked at ASAP.
Dec 18, 2010 at 5:18 PM
Avatar
OBXAUTOMEDIC
  • CAR REPAIR CONTRIBUTOR
  • 3,711 POSTS
Hi Mike,

It could be a couple different problems, I don't think it is the CV Axle it usually makes a Ticking/Clicking Noise.

First things I would check is the Strut Bushings and the Lower Control Arm Bushings. Also check the tire for Bulges in tread.

.
Dec 23, 2010 at 3:40 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.