Saturday, January 5th, 2013 AT 1:38 PM
ANONYMOUS
- MEMBER
- 1995 FORD THUNDERBIRD
How to replace turn signal switch
How to replace turn signal switch
1 Reply
ASEMASTER6371
- MECHANIC
- 52,797 POSTS
Disconnect battery ground cable.
Remove lower LH finish panel retaining bolts and carefully pull to disengage retaining clips.
Remove lower LH reinforcement panel retaining bolts and remove panel.
Remove steering column lower shroud retaining screws and remove lower shroud.
Remove steering column retaining nuts, then remove column upper shroud.
Disconnect switch electrical connectors.
Remove switch retaining bolts, then remove switch.
Reverse procedure to install.
Remove lower LH finish panel retaining bolts and carefully pull to disengage retaining clips.
Remove lower LH reinforcement panel retaining bolts and remove panel.
Remove steering column lower shroud retaining screws and remove lower shroud.
Remove steering column retaining nuts, then remove column upper shroud.
Disconnect switch electrical connectors.
Remove switch retaining bolts, then remove switch.
Reverse procedure to install.
SPONSORED LINKS
Was this helpful?
Yes
No
Saturday, January 5th, 2013 AT 3:24 PM
Related Turn Signal Switch Replace/Remove Content
Sponsored links
SPONSORED LINKS
