1995 Chevrolet Silverado • V8 4WD Manual • 174,000 miles
The clutch finally went out after 174k miles. I replaced the clutch, pressure plate, throwout bearing, pilot bearing, slave cylinder, hydraulic line and surfaced the flywheel. Once back together, the clutch will not disengage enough to let the transmission go into gear. I then replaced the master cylinder and clutch fork as well as shimmed the flywheel 0.050". I still have the same problem. Any suggestions?
July 18, 2011.
July 18, 2011.
96 ford ranger 2.3l 2wd---hard to get into gear and grinds someitmes going into reverse. replaced- master cylinder, slave cylinder, throwout bearing, pressure plate, clutch disk, ...
3 answers • 1996 Ford Ranger • 192,000 miles
1998 Ford Mustang : I recently took my Mustang GT into a Ford service center for a slipping clutch. They told me that I have a self-adjusting clutch and that the clutch assembly needed ...
1 answer • 1998 Ford Mustang
1995 Nissan Maxima SE. Clutch began slipping about a week ago, then 'broke' loose and went to the floor as I was downshifting from 5th to 4th. Kabam! all the way to the floor and no ...
3 answers • 1995 Nissan Maxima • 270,000 miles
My car has been revving up even while in 5th gear and running on unusually high rpm's when any gas is applied, and it has had a burning brake smell if I drove it very far. Recently,the ...
2 answers • 2003 Mitsubishi Lancer • 130,000 miles