Mechanics

HONDA CIVIC SENSOR PROBLEM

1994 Honda Civic • 200,000 miles

Can I spray carb cleaner inside intake manifold when I pullout my iat sensor?
AD
Avatar
Guest
November 20, 2012.



Yes you can. Why?

Roy


ASEMaster6371
Nov 20, 2012.
I always encounter cel at low speed but my car runs good code 10 flash when I diagnose it


Tiny
Gerardryanquerimit
Nov 20, 2012.
And you are adding fuel, why?

Roy


ASEMaster6371
Nov 20, 2012.
I always encounter cel at low speed but my car runs good code 10 flash when I diagnose it or do I need to replace my iat?


Tiny
Gerardryanquerimit
Nov 20, 2012.
Temperature/Resistance values for the Intake Air Temperature Sensor are given below.
Sensor values are monitored by the On-board Diagnostic function of the Engine Control Module (ECM) and detected problems will set Diagnostic Trouble Code (DTC) 10.

Intake Air temperature Resistance
-4°F (-20°C) 20K Ohms
32°F (0°C) 5K Ohms
104°F (40°C) 1K Ohms
176°F (80°C) 350 Ohms
248°F (120°C) 100 Ohms

since you provided no motor info, I gave this generic description

Roy


ASEMaster6371
Nov 20, 2012.
I already done that procedure once cel was gone for 1day use but now its back


Tiny
Gerardryanquerimit
Nov 20, 2012.
Did the sensor, including the new have the correct readings? If so, then check wiring and the last is the ecm

Roy


ASEMaster6371
Nov 20, 2012.
Do I need to reset my ecu?


Tiny
Gerardryanquerimit
Nov 20, 2012.
No, does not apply to pre 96 cars

Roy
AD


ASEMaster6371
Nov 20, 2012.
I dont have diagnostic tools just defending on the blinks in dash


Tiny
Gerardryanquerimit
Nov 20, 2012.
Page 1 of 2

AD