how to to replace switch
May 4, 2012 at 2:22 AM
how to change multifonctionswitch
1994 FORD E-SERIES VAN
MIKE3D
- MEMBER
- 5 POSTS
- FOLLOW
Advertisement
NOTE: On models with tilt column, unscrew the tilt lever and remove.
REMOVAL AND INSTALLATION
Remove steering column shroud.
Remove switch to steering column tube casting attaching screws, then disengage switch from column.
Disconnect switch electrical connectors.
NOTE: Do not damage PRNDL cable.
Remove switch assembly.
Reverse procedure to install. torque switch attaching screws to 18-27 inch lbs .
Roy
REMOVAL AND INSTALLATION
Remove steering column shroud.
Remove switch to steering column tube casting attaching screws, then disengage switch from column.
Disconnect switch electrical connectors.
NOTE: Do not damage PRNDL cable.
Remove switch assembly.
Reverse procedure to install. torque switch attaching screws to 18-27 inch lbs .
Roy
May 4, 2012 at 2:24 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.