i have a 93 ford bronco 5.8 with E4OD tran. but it shifts real hard and clunks on deceleration
Nov 24, 2010 at 12:40 AM
bronco tranny
1993 FORD BRONCO
KEITH0710
- MEMBER
- 1 POST
- FOLLOW
Advertisement
the E4DO is a computerized transmission you'll have to retrieve codes before I can assist.
RETRIEVING CODES
Service codes are retrieved from EEC-IV system through self-test connector. Various methods and test equipment may be used to access these codes:
Analog Volt-Ohmmeter (VOM)
Scan Tester
In-Dash Malfunction Indicator Light (MIL) or CHECK ENGINE light STAR Series Tester
DATA LINK CONNECTOR (DLC) LOCATIONS
Application Location
Bronco & "F"Series Left Front Inner Fender Panel"E" Series Right Front Inner Fender Panel
If you have no codes is not the transmission. Have you checked your use joints in your driveline? what about the rear end? how much backlash is in the gears?
RETRIEVING CODES
Service codes are retrieved from EEC-IV system through self-test connector. Various methods and test equipment may be used to access these codes:
Analog Volt-Ohmmeter (VOM)
Scan Tester
In-Dash Malfunction Indicator Light (MIL) or CHECK ENGINE light STAR Series Tester
DATA LINK CONNECTOR (DLC) LOCATIONS
Application Location
Bronco & "F"Series Left Front Inner Fender Panel"E" Series Right Front Inner Fender Panel
If you have no codes is not the transmission. Have you checked your use joints in your driveline? what about the rear end? how much backlash is in the gears?
Nov 24, 2010 at 5:54 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.