SPONSORED LINKS

93 Bronco starter solenoid problems

Tiny
STR82ZER0
  • MEMBER
  • 1993 FORD BRONCO
  • V8
  • 4WD
  • AUTOMATIC
  • 140 MILES
It all started last week when I didnt get any power to anything on the starting system, no clicks or high pitched noises at all. So I replaced the starter and the starter solenoid and shed start right up, for about a day. Then all I get is a click from the solenoid everytime I try to turn it over. So I replaced the solenoid again with a z rated only to have it start 3 or 4 times and then back to the clicking from the solenoid. Its like I keep blowing the solenoid jus by starting it. No idea where to begin =/
SPONSORED LINKS
Saturday, April 30th, 2011 AT 6:05 PM

1 Reply

Tiny
CARADIODOC
  • MECHANIC
  • 33,741 POSTS
Use a test light to measure the voltage on both of the large copper studs on the solenoid while a helper turns the ignition switch to "crank".

There are three different circuits that Ford used. Do you have a single large cable at the starter or do you have that and a smaller wire at the starter?
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
-1
Saturday, April 30th, 2011 AT 8:57 PM

Please login or register to post a reply.

Related Starter Solenoid Replace/Remove Content

VIEW MORE

Sponsored links