1)Purchased HID Headlight kit to replace stock Halogens. Did not work right. THEN bought pair of "Sealed-Beam Projection Halogens". First problem: Male plug on rear of NEW lights, different configuration than vehicles FEMALE harness plug. I cut 6 new sections of wire, and crimped & soldered new connectors on each end. (a 'blade' type on end to insert into harness, & opposite to slip onto 'blades' of new light) Does ANYONE make an 'adapter' for this? Second problem: The lights work, and both switch back & fort between Hi & Lo beam, BUT the Lo-Beam is VERY DIM! (orangish in color) WHY???

2)How do I access the spark plugs closest to firewall? What MUST be removed to replace them???

THANK YOU VERY MUCH!!!

p.s. image of 'kit plug' is same config. as new headlamp