Yeah their I'd no codes. It just shows 7.0 that is it.

Response from sean03
160 questions asked

u needed to do what khl said.test for power with key on on the pink wire and ground on black.as simple as that.

Answered by cadieman (expert)
2,852 answers provided

Ok so I just did this a few seconds ago after you posted I put the positive on the pink wire and the negative on the black wire. It showed 12 volts exact on my volt meter with the car on the run position not started.

Response from sean03
160 questions asked

go to 7.0 then turn on the cruise it should say 7.1 hit the brake 7.2 set button 7.3 resume 7.4

Answered by cadieman (expert)
2,852 answers provided

Ok so I am going to turn the car to the run position and do the off a warmer button and let it go to the 7.0 then turn the lever on and it should go to 7.1 then hit the brake and it should go to 7.2 then hit the set button and it should go to 7.3 and then hit resume and it should go to 7.4 is this correct or do I have to start the car when I do this and drive it or just start it or just the key to the run position. Thanks.

Response from sean03
160 questions asked

key on this is a switch test.it tells u if the cpu is receiving a signal.sounds like that servo is ng.

Answered by cadieman (expert)
2,852 answers provided

good night

Answered by cadieman (expert)
2,852 answers provided

Ok thanks I will do this tomorrow and let you know what happens. Thanks for the help today.

Response from sean03
160 questions asked

Ok so when I turned on the cruise it came up with e.7.0 then when I hit the brake and did the other things it said e.0.0 and it kept flashing back and fourth from e.7.0 to e.0.0

Response from sean03
160 questions asked

Hi I am reporting this message again. Ok so when I turned on the cruise it came up with e.7.0 then when I hit the brake and did the other things it said e.0.0 and it kept flashing back and fourth from e.7.0 to e.0.0.

Response from sean03
160 questions asked