1990 Jeep Wrangler engine stops

1990 JEEP WRANGLER
167,000 MILES • 4WD • MANUAL
Avatar
SUBARUPWR09
  • MEMBER
  • 4 POSTS
So I just bought a 1990 Jeep Wrangler. Test drove it ran great and got a good deal on it. So I was driving it home and stopped and got gas. Drove for probably another 8-12 miles and the engine just stopped. I tried cranking it over and it just will not start. It fires but will not start. What could this be? Bad gas? Fuel pump? What? Any help would be great thanks!
Dec 19, 2010 at 12:21 AM
Advertisement
Avatar
RASMATAZ
  • CAR REPAIR CONTRIBUTOR
  • 75,992 POSTS
Check the fuel pressure with a fuel pressure tester to rule out the fuel filter and fuel pump-start here
Dec 19, 2010 at 12:53 AM
Avatar
SUBARUPWR09
  • MEMBER
  • 4 POSTS
How is it you would check this?
Dec 19, 2010 at 12:59 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.