1990 Dodge Van Repair Question
Topics covered: Sensor, Crankshaft, Spark.
Mileage: No information provided.
Mileage: No information provided.
Asked on February 19, 2011
Crankshaft position sensor
Replied on February 21, 2011
ok great. i will get one then. do you have any other suggestions on what the problem could be?
Replied on February 21, 2011
ASD relay or coil faulty
Replied on February 28, 2011
Well we replaced the coil tonight, and it still didn't start...
Replied on December 8, 2011
No crankshaft position sensor but it does have a camshaft positioning sensor located in the bottom of the distributor.If it is bad you will have no spark. Turn the ignition switch off and on 3 times, (leaving in the on position, and count how many times the check engine light flashes.
The codes are 2 digit numbers read as # short pause # then long pause on to next code. If you get a code 11 the crankshaft sensor didn't put out a signal while cranking which would cause no spark. Code 55 means end test. Look on the net for Dodge OBD 1 chart.