1989 Ford Ranger Repair Question
Topics covered: Clutch, Clutch master.
Mileage: No information provided.
Mileage: No information provided.
Asked on August 16, 2012
Why fluid is not going through bleed valve, what operated the check valve or plunger?
I have replace the slave cylinder, the clutch master cylinder, and the Hydraulic line, when i try to bleed the slave cylinder, no fluid or air is coming out the bleed valve, but when i push the check valve in at the end of line where it go into slave cylinder fluid come out the line then.
Asked by joe1953Answer
Replied on August 16, 2012
you may have a failed master cylinder. check it for pressure at the line at the top.
Roy
Replied on August 16, 2012
i will have to take the master cylinder of to remove the line, because the line fit into the master cylinder and then a pin go through it, is there another way i can check for pressure, i want to about the plunger at the other end how it work.
Replied on August 16, 2012
remove the line from the bellhousing and pump the pedal and see if there is any pressure.
Roy
Replied on August 16, 2012
if i remove the line from the bellhousing and pump the pedal if there no pressure then or no fluid run out the line, what i do next.
Replied on August 16, 2012
replace the master cylinder
Roy