1989 Chevrolet S-10 Repair Question
Asked on January 30, 2012
Brake system failure
I have replaced the master cylinder and lower flex lines. but my brakes will some times go to the floor and other times stops just fine. what else should i try? i have bleed the brakes over and over already.
Asked by Keith YeomanAnswer
Replied on January 30, 2012
REMOVE THE MASTER CYL. COVER AND FILL.THEN OPEN THE BLEEDERS.U WILL SEE IT START TO GRAVITY BLEED WHEN U SEE THE BUBBLES ARE GONE ITS JUST DRIPPING FLUID TIGHTEN BLEEDERS.REFILL THE MASTER MAKE SURE THE MASTER DOESNT GO DRY WHYLL BLEEDING
Replied on January 30, 2012
Was the master ever bench bled? And yes you can do it by gravity bleed method.