SPONSORED LINKS

Fuel

Tiny
69SIGNAL
  • MEMBER
  • 1988 GMC S15
  • 4 CYL
  • 2WD
  • MANUAL
  • 261,875 MILES
I have a GMC S-15 1988, I replace the gas pump, and the sending unit but the truck even with a full tank it reads at thje guage that is 3/4 and sometimes reads less and goes back up to full. Its allways fluctuating the reading. It is posible that the guage in the dashboard it is damage?
SPONSORED LINKS
Monday, February 21st, 2011 AT 10:32 PM

1 Reply

Tiny
HMAC300
  • MECHANIC
  • 48,601 POSTS
It could be, check to see if you get power to the sending unit, it may flash witha test light which is ok. If it does, make sure your ground wire is conected good and has a good connection. If you ground out he flashing wire and gauge goes to full and stays there while connected, usually the gauge is good.
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
Thursday, February 24th, 2011 AT 10:21 PM

Please login or register to post a reply.

Related Fuel System Fuel Pump Replace/Remove Content

Fuel Pump Replacement
GUIDE
Fuel Pump Replacement
When a fuel pump goes out it can do so one of two ways either it can quit and stop working or it can fail intermittently causing the engine to stall or not start.
VIEW MORE

Sponsored links