you will have to replace the barrel and key, also just make sure that the switch is attached to the lock correctly

Answered by mhpautos (expert)
26,879 answers provided

youll need to replace the key cylinder.you have to removed the wheel and turn signal switch,so you can axcess the cylinder release.

Answered by cadieman (expert)
2,849 answers provided

IS THE "L" SHAPED ROD HOOKED IN THE SWITCH?

CAN YOU FEEL THE ROD MOVE FORE AND AFT, IF YOU PUT YOUR FINGERS ON IT BEHIND THE DASH....THEN TURN THE KEY?

SEE MY LINK...SEE THE ROD?

http://www.2carpros.com/questions/1989-ford-f-250-remove-ignition

ANYTHING YOU AIN'T ALREADY DONE?

THE MEDIC

Answered by CJ MEDEVAC (expert)
6,797 answers provided