SPONSORED LINKS

1985 Dodge 600 No power to coilput

Tiny
RON MARKS
  • MEMBER
  • 1985 DODGE 600
  • 90,000 MILES
Put in new ignition pickup in distributor, replaced power module, all fuses good but still no power to coil where do I start all connections are good the car ran hit a bump and died now won't start what else can I try is there a cut off switch
Friday, November 1st, 2013 AT 4:03 AM

5 Replies

Tiny
JACOBANDNICKOLAS
  • MECHANIC
  • 108,133 POSTS
It's been a while since I worked on an 85. Do you have a crank sensor on this vehicle?
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
Friday, November 1st, 2013 AT 5:03 AM
Tiny
RON MARKS
  • MEMBER
  • 3 POSTS
No it has distributor and I bought a new ignition pickup that goes under rotor in distributor
Was this
answer
helpful?
Yes
No
Friday, November 1st, 2013 AT 6:45 AM
Tiny
JACOBANDNICKOLAS
  • MECHANIC
  • 108,133 POSTS
Do you have a seperate ignition control module?
Was this
answer
helpful?
Yes
No
Friday, November 1st, 2013 AT 8:12 AM
Tiny
RON MARKS
  • MEMBER
  • 3 POSTS
The power module on fender that looks like an air box I replaced that also
Was this
answer
helpful?
Yes
No
Friday, November 1st, 2013 AT 11:35 AM
Tiny
JACOBANDNICKOLAS
  • MECHANIC
  • 108,133 POSTS
Have you checked for power (to the coil) right at the control module? You could have a broken wire.
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
-1
Friday, November 1st, 2013 AT 4:53 PM

Please login or register to post a reply.

Sponsored links