Windshield wipers not working

Tiny
GHPCAR
  • MEMBER
  • 1992 CHRYSLER NEW YORKER
Six cylinder front wheel drive automatic 120,000 miles

Windshield wipers stopped working; have replaced motor and fuse; checked switch at steering column and wiper relay and both are good. When I turn the switch on I can hear the relay go on and off depending on the position of the switch setting. I checked for electrical current at plug to motor end and there is some current; what else could be the problem?
Do you
have the same problem?
Yes
No
Monday, March 1st, 2010 AT 2:29 PM

7 Replies

Tiny
CARADIODOC
  • MECHANIC
  • 33,699 POSTS
Put the wipers on steady slow or fast, then instead of measuring the voltage at the connector, measure the voltage on the wiper motor case. The voltmeter or test light should be grounded to the engine or battery negative post.

When you find voltage on the case, push on the mounting plate and the motor will start to run. The plate is mounted on three rubber isolators to dampen vibration. To get a ground, there is a brass strip riveted to the plate by the lower left bolt. A ring is burned around that strip under the bolt head. Do not bother trying to clean it up. That rarely lasts. Instead, bolt a new ground wire to the mounting plate and bolt the other end to the body sheet metal.

One other note. There must be twelve volts on two terminals at the motor. One from the wiper switch, and one whenever the ignition switch is turned on for the "park" circuit to keep the motor running after the wiper switch is turned off. If one of those voltages is missing, suspect a blown fuse due to your old motor was shorted. It was quite common for one of the contacts on the rotary switch in the motor gear train to overheat. It would melt into the plastic gear when the motor was turned off. The next time the motor started to run, that contact would get stretched and bent up until it touched the metal cover. That popped the fuse. Chances are your old motor is okay if you have the ground problem. It is not likely to develop both problems at the same time.

Caradiodoc
Was this
answer
helpful?
Yes
No
+1
Wednesday, March 3rd, 2010 AT 1:10 PM
Tiny
CHEY11MOM
  • MEMBER
  • 2 POSTS
  • 1983 CHRYSLER NEW YORKER
Where is the circuit breaker located? The windshield wipers do not work.
Was this
answer
helpful?
Yes
No
Friday, December 30th, 2016 AT 2:07 PM (Merged)
Tiny
JACOBANDNICKOLAS
  • MECHANIC
  • 108,005 POSTS
Check fuses under the dash as well as the ones under the hood in the power distribution box.
Was this
answer
helpful?
Yes
No
+1
Friday, December 30th, 2016 AT 2:07 PM (Merged)
Tiny
CHEY11MOM
  • MEMBER
  • 2 POSTS
Thank you so much.
Was this
answer
helpful?
Yes
No
Friday, December 30th, 2016 AT 2:07 PM (Merged)
Tiny
JACOBANDNICKOLAS
  • MECHANIC
  • 108,005 POSTS
Glad to help. Let me know what you find or if you have other questions.
Was this
answer
helpful?
Yes
No
Friday, December 30th, 2016 AT 2:07 PM (Merged)
Tiny
JACKIE85
  • MEMBER
  • 1 POST
  • CHRYSLER NEW YORKER
Just this morning I took my husband to work and on the way there the windshield wipers worked fine, but on the way home the one on the drives side will not come up. If I make it go up half way it will go all the way but once it goes down it will not come back up. It is a great car but the windshield wiper just will not work now.
Was this
answer
helpful?
Yes
No
Friday, December 30th, 2016 AT 2:07 PM (Merged)
Tiny
BOOTDOG
  • MECHANIC
  • 665 POSTS
Either the splines on the wiper arm are worn, or the splines that the arm fastens to are worn.
Was this
answer
helpful?
Yes
No
Friday, December 30th, 2016 AT 2:07 PM (Merged)

Please login or register to post a reply.

Sponsored links