Free Auto Repair Advice by Professional Mechanics
Automobile /
Geo /
Tracker
Geo Tracker Car Repair Questions and Answers

Question: 1993 Geo Tracker 4
cyl four wheel drive Automatic 30056 miles. what is a manual hub and where do I
find it to change to 4wd?
Answer: Manual hubs are
located in the center of the hub where the front wheel mounts. Should have 2
marks on it "lock" and "free" turn with your hand or if too tough, carefully use
pliers
Question: 1996 Geo Tracker 4
cyl Two Wheel Drive Automatic 83,000 miles. I have this geo tracker that
hesitates into forward. any suggestions. this happened after rebuild. thank you
in advance
Answer: It happened after the
tranny was rebuilt? Take it back to the re builder, there is a pressure problem!
Question: 1996 Geo Tracker 4
cyl four wheel drive Automatic 120,000 miles Left rear brake drags and gets hot.
Right front also drags slightly. Replaced left rear wheel cylinder. When left
rear shoe adjusts, they drag again. Return springs seem fine. Is this a master
cylinder issue? Any way to repair or fix this without replacement? Could I just
flush the system or examine the master cylinder for anything that's broken or
not in place?
Answer: You can check the
injector pulse with a node light. There are also some relay's that could be bad,
or try some sitar in the throttle body, if it runs a few seconds and dies, the
fuel pressure or injectors. If it doesn't fire at all, then spark, distributor
equipped cars have an ignition module that can go bad. Module is located inside
the distributor, believe it or not you can buy a reman'd distributor w/new
ignition module cheaper than the module itself.
Question: 1997 Geo Tracker 4
cyl Two Wheel Drive Automatic 105,00 miles. Where is the pcv valve located on my
Geo? I was told it was on the valve cover but there is nothing visible, is it
buried under something?
Answer: If not in the front,
in the rear.
Question: 1994 Geo Tracker 4
cyl Four Wheel Drive Manual 140,000 miles. How to remove locknut without buying
special socket?
Answer: The best thing is to
use a socket, years ago we used a hammer and chissel. if you really don't know
how to do it then I wouldn't advise it. borrow a socket from somebody, some
places like auto zone do lend out tools try that.
Question: 1996 Geo Tracker
Two Wheel Drive Automatic 99,912 miles. How do we open the hood, we have looked
all over the driver side compartment and could not find the hood release.
Answer: The hood latch is in
the glove box, upper part.
Question: I have a 1991 Geo
Tracker and the fuel gauge never moves, it stays at 3/4 full at all times. Any
suggestions on what may be causing this?
Answer: It could be as simple
as a loose wire, or as tough as having to replace the sending unit in the fuel
tank. You'll have to trace the wire from the gauge to the tank for beginners.
Question: I have a 96 Geo
Tracker with about 150,000 on it when I got up this morning and started to drive
the car I heard a strange noise coming from the dash around the speedometer
suddenly it jus went from the normal speed I was going to 100 then when I slowed
down it went back to normal but as soon as I tried to go over 35 it acted up
again so I'm no sure if its the Sensor or the Cable
Answer: Open the dash up and
investigate the speedo head and cable-probably came loose or worn drive.
Question Follow Up:
I opened the dash and changed the
cable but i think its were the cable goes in that is the problem anyone know
where i can get the part do i have to go directly to the Chevy Dealership or can
I get from a salvage place?
Answer Follow Up:
Get it from the junkyard dogs-its
cheaper
Question: Where is the fuel
filter on a 91 GEO Tracker ?
Answer: If
you look under the back end, directly in front of your gas tank, it is mounted
to the floor/frame towards the passenger side, look in front of the tank and you
should be able to see it
Question: My Geo Tracker '94
with 50,000 miles is stuck in park. It start nicely but when I push the back
drive button it is still stuck in park. I took the steering wheel and pushed the
back drive cable to its full range with no help. All fuses are good.
Answer: There is a little
cover on the left side of the shifter console. Remove the one screw and if you
reach inside you'll find a short lever that you move (i think towards the rear)
one way or the other and that will manually release the shifter if your key is
on and the brake is depressed. Now you can take it to somebody that can diagnose
your trouble.
Question: 95 geo tracker
160,000 miles, 1.6L, check engine light just came on, went to check the codes,
with a snap-on code checker, and it said there was a 6 pin connector , by the
left strut tower at the firewall that needed 2 pins shorted, I cant find it, how
do I check the codes?
Answer: The connector on my
95 geo is actually just in front of the battery at the bottom center. It has a
rubber cover over it. If you short the same ones as when you time the car then
you need to run a wire between number 4 and 5 holes. Begin number one with the
hole with nothing in it and count left to right.
Question: Hello. Can a 1990
Geo Tracker engine (or at least the crankshaft) go into a 1994 Geo Tracker?
Thank you
Answer: Is the 8th digit of
the vin# the same? If so then they should be interchangeable as far as the block
and head. I would use all external parts off the old engine that is the correct
year
Question: Hey guys my
question is an 1991 geo tracker, turn the key nothing happens, its a 5 speed can
push to start but soon as I turn off it wont start back, I cleaned the post and
cable still nothing, when I try to use cables to jump off nothing happens, what
should I try next?
Answer: I assume the battery
is good. There is a switch that when the clutch is depressed, will allow the key
to start the motor cranking.

Automobile /
Geo /
Tracker
Look up more Geo Tracker Questions in our Car Repair forum section.
Try looking up your problem in our
auto repair topics section
Got a Geo Tracker Repair Question?
We will
answer it for free.
Related Subjects
GET AN ONLINE
CAR REPAIR
MANUAL. Get instant access to your vehicles drive belt
routing, wiring diagrams, trouble code information, updates and
factory bulletins.
|