The air flow through the vents after the key is off is due to the fan motors final stage failure. Replace the final stage with part# 64-11-8-385-549, this module is installed in the air stream in the heater box and you will need to remove the glove box and carpet trim to gain access . As to the key failure, the key(s) need to be reinitialized. Procedure is as follows, get in the drivers seat and close the door, put the key in the ignition and turn it to the KL-15 position (key on but do not start) then turn the key off and remove it, then hold the unlock button down while you push the lock button three times, the door locks should all then lock and then unlock, repeat the procedure with the second key and you should have keyless entry function again.