Transmission problem
2000 Chrysler Sebring 6 cyl Front Wheel Drive Automatic 106000 miles

part is avail, how do I remove the trans shift solonoid, located on the front of the trans under the car.

Hello
Thanks for donating.

To better assist you with this, could you please let me know if the model is the JX JXi LIMITED LX or LXi ?

This Chrysler is a 2000 sebring convertable jxi/ front wheel drive v6 2.5 litre.

Thanks

Thanks for that info.
Below is the info. you requested.

Remove any components that may be in the way of easy access.
Clean the area very well so that sand or dirt does not fall into the holes after you remove the solenoid pack.
Remove the bolts holding the solenoid pack down. Remove the solenoid sensor wire.
Remove any remaining dirt before installation.





Reverse for installation.

Where are the bolts that hold the solonoid down? are they on top or bottom of the solonoid? do you have any pictures to send for the situation?

Picture is above in previous post.

I could not find, in my resources, the exact positioning of the bolts but I will ask a fellow tech and get back with you on this in just a few minutes.

Sorry took so long. Below is exploded diagram.