Car Repair Advice by Professional Automotive Experts
Welcome to 2CarPros.com free car repair question and answer forum. Our certified technicians answer over 10,000 questions every month. Asking a question is easy, just click the “Ask a Car Repair Question” link in our site menu and join our community. We have short form where you input year/make/model and specific details of your problem. All questions are automatically posted in model specific forums. We will notify you at the email address you signed up with once an answer has been posted. To follow up with our technician, use the “reply to question” button below the answer. If your question is urgent and requires immediate assistance, we have a preferred option; if you elect to donate a small sum of your choice, we will guarantee an answer from one of our certified technicians within 24 hours. If we are not able to help you, we will gladly return your donation.
1998 Chrysler Town and Country Door Locks
| |
|
|
|
|
Posted at Tue Feb 09, 2010 4:04 am |
|
By
georgenglish,
Have Donated |
|
(63) Give Feedback | Votes: 0 |
|
|
|
|
|
Electrical problem
1998 Chrysler Town and Country 6 cyl Two Wheel Drive Automatic 106842 miles
Please, changed battery recently, since then door actuator goes off and on when the the car is locked, tried removing the fuse, disconnecting the battery, none of this works, have to remove fuse so battrey wont run down ? Thanks, George |
| |
Find a
car repair manual for your Chrysler Town and Country Repair Question.
|
|
|
|
 |
 |
|
|
Posted at Wed Feb 10, 2010 3:19 am |
|
By
Service Writer,
Certified 2CarPros Master Technician |
 (7324) Give Feedback | Votes: 98 |
|
|
|
|
|
BCMs are common on these. IF you disconnect the bcm and the locks stop cycling, you may have found the bcm is bad.
However, the door courtesy light switches can be pushed in to far. This switch is adjustable. Pull the center outward, then close the door. If it has a rubber boot on it, remove it. When you close the door, it will reset the switch with the proper tension. Usually it is the sliding door switch in the c-pillar at the back of the door opening. They get lots of abuse from the doors being slammed and tend to start making erroneous signals with only a slight amount of movement. clean off the contact pads on the sliding doors if they are dirty, any movement will cause a change in voltage, which the bcm might see as a open/closed request. |
| |
Find a
car repair manual for your Chrysler Town and Country Repair Question.
|
|
|
|
|
|
 |
|
|
|
|
|
|
|
Make a small donation! (We will make
sure your question will be answered promptly)
|
| |
|
|
|
| |
|
Find a repair manual
for your car - Get instant access to your
vehicles drive belt routing, wiring diagrams,
trouble code information and other available
updates and factory bulletins. Click
here to find out more. |
|
|
|
|
|
Go Back
Register
Log in
Profile
Search
FAQ
