Brakes problem
1992 Lincoln Continental 6 cyl Two Wheel Drive Automatic

i PUTTING NEW BRAKE ON THE BACK AND THE PISOTON WILL NOT GO IN
HOW DO GET IT TO BACK UP

DISC & DRUM -1992 Lincoln Continental Executive
Page 1 of 1
Installation
1.When installing new brake pads, caliper piston must be properly retracted. Using Piston Remover (T87P-2588-A), rotate piston clockwise until piston is fully seated. 2.Ensure one of slots in piston face is positioned so it will engage nib on brake pad. See Fig. 4 . Install brake pads, anti-rattle springs and brake caliper. 3.Ensure brake pads are properly positioned. Clean pinch bolt threads and apply one drop of Threadlock and Sealer (EOAC-16554-A). To complete installation, reverse removal procedure. Bleed brakes. See BLEEDING BRAKE SYSTEM . Adjust parking brake as necessary. See PARKING BRAKE under ADJUSTMENTS.
Fig. 4: Positioning Piston in Caliper
Courtesy of FORD MOTOR CO.


© 2007 Mitchell Repair Information Co., LLC.
http://www.ondemand5.com/mric/common/asp/printart.aspx
10/10/2008